Exam Questions – TM-2.3.1

Search: "defect report"

Sample Exam Questions

CTAL-TM LO: TM-2.3.1 2 questions

Learning Objective: Implement a defect management process, including the defect workflow, that can be used to monitor and control defects

Download PDFs:

Sample Exam A Questions PDF Answers PDF

Sample Exam A v1.3.3 Questions PDF p.27 Answers PDF p.34

Q34

K3 TM-2.3.1

As a tester you are typically required to create a defect report whenever you observe a defect during testing. However, there may be situations where you might not create a defect report. Which of the following is a reason why a defect report may NOT be created after a defect is detected by a test?

Select ONE option.

A.
The failure is caused by a defect that was introduced in the same phase as the test.
B.
The failure is caused by a defect that is not to be tracked within the defect workflow.
C.
The failure is caused by an invalid test that does not match the requirements specification.
D.
The failure is caused by an anomaly that is not observed by the tester.

Sample Exam A v1.3.3 Questions PDF p.27 Answers PDF p.35

Q35

K3 TM-2.3.1

The diagram shows an incomplete defect workflow, where two states (states X and Y) have yet to be named appropriately.

Which of the following would correctly complete the workflow?

Select ONE option.

A.
STATE X – RETESTED STATE Y – RE-OPENED
B.
STATE X – REJECTED STATE Y – CLARIFICATION
C.
STATE X – DUPLICATE STATE Y – TERMINATED
D.
STATE X – FIXED STATE Y – REJECTED

Share Your Feedback